11:44:24 M122 === Diagnostics === Used output buffers: 7 of 32 (13 max) === Platform === RepRapFirmware for Duet 2 WiFi/Ethernet version 1.21 running on Duet Ethernet 1.02 or later Board ID: 08DDM-9FAM2-LW4S8-6J9FJ-3SJ6P-TJXMY Static ram used: 16152 Dynamic ram used: 100016 Recycled dynamic ram: 2616 Stack ram used: 1224 current, 4528 maximum Never used ram: 7760 Last reset 00:16:48 ago, cause: power up Last software reset at 2018-04-28 11:24, reason: User, spinning module GCodes, available RAM 7760 bytes (slot 1) Software reset code 0x0003 HFSR 0x00000000, CFSR 0x00000000, ICSR 0x00417000, BFAR 0xe000ed38, SP 0xffffffff Error status: 0 Free file entries: 10 SD card 0 detected, interface speed: 20.0MBytes/sec SD card longest block write time: 0.0ms MCU temperature: min 34.6, current 34.6, max 34.8 Supply voltage: min 24.1, current 24.2, max 24.2, under voltage events: 0, over voltage events: 0 Driver 0: standstill, SG min/max not available Driver 1: standstill, SG min/max not available Driver 2: standstill, SG min/max not available Driver 3: standstill, SG min/max not available Driver 4: standstill, SG min/max not available Date/time: 2018-04-28 11:44:23 Slowest main loop (seconds): 0.004518; fastest: 0.000056 === Move === MaxReps: 0, StepErrors: 0, LaErrors: 0, FreeDm: 240, MinFreeDm 240, MaxWait: 0ms, Underruns: 0, 0 Scheduled moves: 36, completed moves: 36 Bed compensation in use: none Bed probe heights: 0.000 0.000 0.000 0.000 0.000 === Heat === Bed heaters = -1 -1 -1 -1, chamberHeaters = -1 -1 === GCodes === Segments left: 0 Stack records: 1 allocated, 0 in use Movement lock held by null http is idle in state(s) 0 telnet is idle in state(s) 0 file is idle in state(s) 0 serial is idle in state(s) 0 aux is idle in state(s) 0 daemon is idle in state(s) 0 queue is idle in state(s) 0 autopause is idle in state(s) 0 Code queue is empty. === Network === Responder states: HTTP(2) HTTP(1) HTTP(0) HTTP(0) FTP(0) Telnet(0) Telnet(0) HTTP sessions: 1 of 8 === Network === State: 5 HTTP sessions: 1 of 8 === Filament sensors === Extruder 0 sensor: ok === Expansion ===