; Configuration file for Duet WiFi (firmware version 1.17 to 1.19) ; executed by the firmware on start-up ; ; generated by RepRapFirmware Configuration Tool v2 on Sat Apr 20 2019 22:47:08 GMT+0200 (Mitteleuropäische Sommerzeit) ; General preferences G90 ; Send absolute coordinates... M83 ; ...but relative extruder moves M667 S1 ; Select CoreXY mode ; Network M550 P"Solido" ; Set machine name M552 S1 ; Enable network M587 S"XXX" P"XXX" ; Configure access point. You can delete this line once connected M586 P0 S1 ; Enable HTTP M586 P1 S0 ; Disable FTP M586 P2 S0 ; Disable Telnet ; Drives M569 P0 S0 ; Drive 0 goes backwards M569 P1 S0 ; Drive 1 goes backwards M569 P2 S0 ; Drive 2 goes backwards M569 P3 S1 ; Drive 3 goes forwards M569 P4 S1 ; Drive 4 goes forwards M350 X16 Y16 Z16 E16:16 I1 ; Configure microstepping with interpolation M92 X80.00 Y80.00 Z160.00 E800.00:800.00 ; Set steps per mm M566 X1200.00 Y1200.00 Z12.00 E120.00:120.00 ; Set maximum instantaneous speed changes (mm/min) M203 X90000.00 Y90000.00 Z1200.00 E1200.00:1200.00 ; Set maximum speeds (mm/min) M201 X5000.00 Y5000.00 Z300.00 E250.00:250.00 ; Set accelerations (mm/s^2) M906 X800.00 Y800.00 Z1200.00 E800.00:800.00 I0 ; Set motor currents (mA) and motor idle factor in per cent M84 S30 ; Set idle timeout ; Axis Limits M208 X0 Y0 Z0 S1 ; Set axis minima M208 X240 Y320 Z245 S0 ; Set axis maxima ; Endstops M574 Z1 S0 ; Set active low and disabled endstops M574 X1 Y1 S3 ; Set endstops controlled by motor load detection ; Z-Probe M558 P0 H0 F120 T6000 ; Disable Z probe but set dive height, probe speed and travel speed M557 X15:0 Y15:195 S20 ; Define mesh grid ; Heaters M305 P0 T100000 B4138 R4700 ; Set thermistor + ADC parameters for heater 0 M143 H0 S120 ; Set temperature limit for heater 0 to 120C M305 P1 T100000 B4138 R4700 ; Set thermistor + ADC parameters for heater 1 M143 H1 S280 ; Set temperature limit for heater 1 to 280C ; Fans M106 P0 S0 I0 F500 H T45 ; Set fan 0 value, PWM signal inversion and frequency. Thermostatic control is turned on M106 P1 S1 I0 F500 H1 T45 ; Set fan 1 value, PWM signal inversion and frequency. Thermostatic control is turned on ; Tools M563 P0 D0 H1 ; Define tool 0 G10 P0 X0 Y0 Z0 ; Set tool 0 axis offsets G10 P0 R0 S0 ; Set initial tool 0 active and standby temperatures to 0C ; Custom settings are not configured