; Configuration file for Duet WiFi (firmware version 2.03)
; executed by the firmware on start-up
;
; generated by RepRapFirmware Configuration Tool v2.0.4 on Wed Sep 18 2019 19:29:30 GMT+0300 (Eastern European Summer Time)
; Custom config
M584 X0:4 Y1:3                 ; set drive mapping for MPCNC

; General preferences
G90                            ; send absolute coordinates...
M83                            ; ...but relative extruder moves
M550 P"Jyrsin"                 ; set printer name

; Network
M552 S1                        ; enable network
M586 P0 S1                     ; enable HTTP
M586 P1 S0                     ; disable FTP
M586 P2 S0                     ; disable Telnet

; Drives
M569 P0 S0                     ; physical drive 0 goes forwards
M569 P1 S0                     ; physical drive 1 goes forwards
M569 P2 S1                     ; physical drive 2 goes forwards
M569 P3 S1                     ; physical drive 0 goes forwards
M569 P4 S1                     ; physical drive 0 goes forwards
M350 X16 Y16 Z16 I1            ; configure microstepping with interpolation
M92 X80.00 Y80.00 Z400.00      ; set steps per mm
M566 X900.00 Y900.00 Z12.00    ; set maximum instantaneous speed changes (mm/min)
M203 X6000.00 Y6000.00 Z500.00 ; set maximum speeds (mm/min)
M201 X500.00 Y500.00 Z20.00    ; set accelerations (mm/s^2)
M906 X800 Y800 Z800 I30        ; set motor currents (mA) and motor idle factor in per cent
M84 S30                        ; Set idle timeout
M453 P2 R15000                 ; Set Spindle output and max speed

; Axis Limits
M208 X0 Y0 Z-10 S1               ; set axis minima
M208 X435 Y335 Z100 S0         ; set axis maxima

; Endstops
M574 X1 Y1 S3 ; Set active high endstops, use sensorless homing
M915 X Y S30 R2 F1 ; set X and Y to sensitivity 30, pause when stall, filtered

; Z-Probe
M558 P4 C2 H40 I1 F120 T6000          ; disable Z probe but set dive height, probe speed and travel speed

; Heaters
M140  H-1                       ; disable heated bed
;M143 H0 S140
:M305 P1 T100000 B4138 R4700    ; set thermistor + ADC parameters for heater 1
;M143 H1 S280                   ; set temperature limit for heater 1 to 280C
;M452 P1 R255 F200
M307 H3 A-1 C-1 D-1          ; Disable Heater output on H3
M307 H5 A-1 C-1 D-1          ; Disable Heater output on H3
;M452 P3 R255 F200 S1         ; Enable Laser mode, on output 3 (heater 3), with max intensity being 255, and a PWM frequency of 200
M452 C"exp.heater5" Q200 ; laser uses heater3 pin,  PWM frequency 100Hz
M106 P0 S0 I-1 F200 H-1      ; Set fan 0 value, PWM signal inversion and frequency. Thermostatic control is turned off



; Fans


; Custom settings are not defined