2/20/2020, 9:00:45 AM: Connected to 192.168.0.133
2/20/2020, 9:01:04 AM: G28 X: Error: G0/G1: insufficient axes homed
2/20/2020, 9:01:57 AM: G28 Y: Error: Bad command: [/c]
2/20/2020, 9:02:04 AM: G28 Z: Error: G0/G1: insufficient axes homed
2/20/2020, 9:40:21 AM: Upload of config.g successful after 0s
2/20/2020, 9:40:32 AM: Connection interrupted, attempting to reconnect...: Network error
2/20/2020, 9:40:37 AM: Connection established
2/20/2020, 9:41:12 AM: Upload of homex.g successful after 0s
2/20/2020, 9:41:23 AM: Upload of homey.g successful after 0s
2/20/2020, 9:41:32 AM: Upload of homez.g successful after 0s
2/20/2020, 10:28:05 AM: Upload of config.g successful after 0s
2/20/2020, 10:28:16 AM: Connection interrupted, attempting to reconnect...: Network error
2/20/2020, 10:28:19 AM: Connection established
2/20/2020, 10:29:51 AM: Upload of homex.g successful after 0s
2/20/2020, 10:30:14 AM: Upload of homey.g successful after 0s
2/20/2020, 10:30:39 AM: Upload of homez.g successful after 0s
2/20/2020, 10:40:39 AM: M98 P"0:/macros/03-Test_Heaters": Error: M570: Heater 2 not found
Error: M563: Tool creation: bad drive number
Error: G10: Attempt to set/report offsets and temperatures for non-existent tool: 2
2/20/2020, 10:40:49 AM: : Error: G10: Attempt to set/report offsets and temperatures for non-existent tool: 2
2/20/2020, 10:42:01 AM: M98 P"0:/macros/04-Test_motors": Error: GCodes: Attempt to read a GCode float array that is too long: M906 X2000 Y2000 Z2000 E2000:2000 I100 
Error: GCodes: Attempt to read a GCode unsigned array that is too long: M350 X16 Y16 Z16 E16:16 I0			
Error: GCodes: Attempt to read a GCode float array that is too long: M92 X80 Y80 Z80	E80:80				
Error: GCodes: Attempt to read a GCode float array that is too long: M906 X2000 Y2000 Z2000 E2000:2000 I100 		
Warning: Obsolete use of S parameter on G1 command. Use H parameter instead.
Warning: Obsolete use of S parameter on G1 command. Use H parameter instead.
2/20/2020, 10:42:02 AM: : Warning: motor phase A may be disconnected reported by driver(s) 2
Warning: motor phase B may be disconnected reported by driver(s) 2
2/20/2020, 10:42:03 AM: Emergency stop, attemping to reconnect...
2/20/2020, 10:42:15 AM: Connection established