;; Activate the mechanical probe in "fast" mode. ;; Used to quickly get down to switch level. ;; Follow this up with a slow probe to finely calibrate the height. ;; NOTE: Probing with Z0 is a safe value on my printer, ;; so this file never has to change. ;; Tune the Z-value in the "slow" file. ;; ;; *ADJUST* this file for: ;; Your mechanical switch pins ("M558 P*") M558 P4 C2 I0 F200 H2 T18000 A10 S0.02 B1 R0.2 G31 T4 P500 X0 Y0 Z0 ; Set parameters for z switch (if positive, greater value = lower nozzle. if negative, more negative = higher nozzle)