Prusa MK3 - Stall detection help
-
I am just now swapping my Prusa MK3 over to a bear frame and using the Duet Wifi 2 board. I cannot for the life of me get this thing to home correctly. I am using the default Prusa LDO motors. Can someone share the settings for config.g and the home ones so I can see what I am doing wrong? Thanks!
-
I haven't used those particular motors, but the guide to using stall detection is at https://duet3d.dozuki.com/Wiki/Stall_detection_and_sensorless_homing. I find a stall sensitivity of about 3 in the M915 command is good for most motors.
-
@dc42 I think my home commands are not correct. Can you share an example of what it should look like?
-
@dismania said in Prusa MK3 - Stall detection help:
@dc42 I think my home commands are not correct. Can you share an example of what it should look like?
See the link provided above.
-
Chris Warkocki made the settings for Duet and MK3.
See here: https://www.patreon.com/posts/duet-prusa-files-30115916
But try not to just copy the settings, see what he did and try to implement it in your settings.