Duet board setup
-
Hello and thanks to all in advance for your time and help
Very new to the world of cnc. I bought a workbee from ooznest about a year ago and this weekend decided to upgrade the board to the duet 3 ethernet version
So ive come to setting up the board plugged it in via usb and installed YAT
Following the instructions i entered command M552 and it says 'network is disabled'
I than entered M552 S0 it just comes up with 'ok<LF>'
Not sure if this means the board in connected or offline or in idle state
Closed yat reopened and same responses
Any help is appreciated
Link of Image to screenshot of YAT
https://www.dropbox.com/s/r8352jgicc5jim4/20191019_150921.jpg?dl=0
-
Hi,
Unless something has changed M552 S0 means disable networking.
Frederick
-
Hi
M552 S1 enables network. To see network state and ip address, send M552 without any parameter.
-
Thank you