M558 Recovery Time
-
Is it just a RepRapFirmware 1 thing that this can't be less than 1 second? Not tested to see if it is limited to integer values or just over 1 yet...
-
You can use floating point values. We recommend 0.2 or 0.4 for the Smart effector.
More generally, in RRF almost every parameter that represents a continuous value is implemented using floating point arithmetic.
-
@dc42 don't think that's working for R/M558 in RRF1 or the time delay before a heater fault causes the build to cancel.
I'll confirm after I've made today's quota of faceshield frames.
-
You can send M558 without parameters to confirm what the recovery time is set to, even while you are printing.