Parts fan issue.
-
Part Fan issue.
Duet Wifi ... I had very hard time using Fan 0, where I suspect there might be hardware problem ... regardless.
Decided to use 1 and 2 where FAN01 is extruder cooling and FAN02 I have parts fan connected.
FAN01 appears to be doing well kicking in when thermostat kicks in but FAN02 appears to have mind of its own.
I can't stop it (perhaps not sure how), but I set in slicer 0 fan for PETG and the thing still spins at 100%.What am I doing wrong here plz?
Please see attached my fans section:
M950 F0 C"fan2" Q500 ; create fan 0 on pin fan2 and set its frequency M106 P0 S0 H1 T45 ; set fan 0 value. Thermostatic control is turned on M950 F1 C"fan1" Q500 ; create fan 1 on pin fan1 and set its frequency M106 P1 S1 H-1 ; set fan 1 value. Thermostatic control is turned off
Thx !
-
Just to add, tool fan in GUI is showing 0 and its still spinning.
-
Did you change your tool definition to use the new fan?
-
I have not.
; Tools M563 P0 D0 H1 F0 ; define tool 0
So the F0 needs to change to F1
-
@Deepnoizer Not if fan 1 is the thermostatic hot end fan. If you want to use fan 2 for part cooling use F2 in your tool definition. If you want to use both fan 0 and fan 2 for part cooling use F0:2
-
I got it sorted thank you.