Question about PanelDue 7i running 1.24
-
Hi,
With DWC 2.0.7 I can change the value of the Extrusion Speed and Extrusion Amount "buttons".
However my custom values are not showing in the PanelDue 7i v1.24.
Is this expected behavior?
Thanks.
Frederick
-
Unfortunately yes, that setting is just for DWC and not synced to RRF.
-
@bearer said in Question about PanelDue 7i running 1.24:
Unfortunately yes, that setting is just for DWC and not synced to RRF.
Is there anyway to change the values displayed/used by the panel?
Thanks.
Frederick
-
Tinkering in the PanelDue firmware.
-
@Phaedrux said in Question about PanelDue 7i running 1.24:
Tinkering in the PanelDue firmware.
Well that is not happening but good to know just the same.
Frederick