Zprobe setup in Duet v2 FW3.x
-
Hi,
i have do the change to Firmware 3, and i am having issues to setup Zprobe....
The line in config.g for zprobe, in firmware 3 its:
; Z-Probe M558 P8 C"!zprobe.in" R0.8 F150 Z1 ; set Z probe type to unmodulated and the dive height + speeds G31 P500 X0 Y0 Z2.5 ; set Z probe trigger value, offset and trigger height M557 R85 S20 ; define mesh grid
the Zprobe its a Precision Piezo Orion
With this setup... sometimes works and sometimes no... yesterday i acomplish do a calibration and a compensation... in fact, in this post i upload the results of a compesation....
But this morning all changes:
- When i do a single test, the PPO works.
- But when try to calibrate, in some points its triggered before start to test it, and...
- In some points, hot har the bed...
I have try to tighten and loosen, and nothing.
I have try to do the test with fans off
I have try to do the test with bed heater on and offNothing works...
Someone has a Precision Piezo Orion working in Firmware 3? What setup have it?
-
Think i have solved....
NOT Duet configuration issue..... was a mechannical issue....
Seems that with time,the screws holding the Zprobe had loosened