Z Probe trigger Error
-
I have a Duet 2 Wifi and my probe is a BLTouch. I've figured out that one of the crimps on a wire is bad but I noticed that it errors displays the error. I figured after the error was triggered it would stop printing but instead printing continued.
4/20/2021, 4:02:21 PM M0 H1 Printing paused at X5.0 Y40.0 Z0.3 Cancelled printing file 0:/gcodes/Sanding_Block.gcode, print time was 0h 0m 4/20/2021, 4:02:17 PM M25 Resume state saved 4/20/2021, 4:02:14 PM Error: Z probe already triggered before probing move started Height map saved to file 0:/sys/heightmap.csv 4/20/2021, 4:01:36 PM M32 "0:/gcodes/Sanding_Block.gcode" File 0:/gcodes/Sanding_Block.gcode selected for printing 4/20/2021, 4:00:56 PM M0 H1 Printing paused at X5.0 Y220.0 Z0.3 Cancelled printing file 0:/gcodes/Sanding_Block.gcode, print time was 0h 0m 4/20/2021, 4:00:48 PM M25 Resume state saved 4/20/2021, 4:00:44 PM Error: Z probe already triggered before probing move started Height map saved to file 0:/sys/heightmap.csv
Is there a way to prevent the print from continuing if there is an error like that during mesh leveling?
-
There may be a conditional gcode check that could be done, but I'm not sure what that would be off the top of my head.