Solved CoreXY issue
-
Hi All,
I have recently come over from the Marlin world and I am struggling to get my CoreXY setup correct.
Endstops are both located at the front left.
A and B motors are located at the front of the printer.
X+ moves to the right Y+ moves to the front. This is where I am current stuck. (for the record i have been searching for hours but not found a solution)
How do I configure the Y axis to move in the right direction? Other then that everything is working well.
-
Follow through with this and you'll get it right. There is a motor direction test section.
https://duet3d.dozuki.com/Wiki/ConfiguringRepRapFirmwareCoreXYPrinter
-
Thanks
I found my issue. It was the config in my Yhome and end switch was set to high. amazing what a bit of rest does for the brain.