Auto leveling questions with toolboard
-
@pelikán-jiří and if you're just oing to call homez then homeall should look like this
; homeall.g ; called to home all axes ; ; generated by RepRapFirmware Configuration Tool v3.1.10+4-LPC on Tue Jan 19 2021 17:25:01 GMT+0800 (中国标准时间) G91 ; relative positioning G1 H2 Z5 F6000 ; lift Z relative to current position G1 H1 X-240 Y-240 F1800 ; move quickly to X and Y axis endstops and stop there (first pass) G1 H2 X5 Y5 F6000 ; go back a few mm G1 H1 X-240 Y-240 F360 ; move slowly to X and Y axis endstops once more (second pass) G90 M98 P"homez.g"
-
@jay_s_uk
Thank you very much, at the moment the head always stops roughly in the middle of the bed just above it. But I don't know why, but the meshgrid setting doesn't work. I have the dimensions entered, but the probing always starts outside the bed. -
@pelikán-jiří have you set the X and Y offsets of the bltouch?
-
@jay_s_uk said in Auto leveling questions with toolboard:
@pelikán-jiří have you set the X and Y offsets of the bltouch?
Yes set. But suddenly it stopped working.
; Z-Probe Bltouch M950 S0 C"servo0" ; create servo pin 0 for BLTouch M558 P9 C"^probe" H7 F120 T6000 ; set Z probe type to bltouch and the dive height + speeds G31 P500 X44 Y0 Z1.6 ; set Z probe trigger value, offset and trigger height M557 X45:230 Y40:215 S40 ; define mesh grid
-
I tried to find the error, but I have everything set up, but the meshgrid still doesn't work.
-
@pelikán-jiří how far off the bed is the first probe point?
-
@jay_s_uk
About 24 mm away. And I have it set to x60 -
@pelikán-jiří said in Auto leveling questions with toolboard:
@jay_s_uk
About 24 mm away. And I have it set to x60And bed leveling also works unevenly, don't you know what the problem might be? I have already managed to start a functional autoleveling, but when I start printing, one side of the bed is too high and the other too low, because the motor balances the bed incorrectly.
-
@phaedrux said in Auto leveling questions with toolboard:
the results of M122 and M98 P"config.g".
I think if you send M98 P"config.g" you'll see some errors that your pinnames being used for the BLtouch are not correct.
C"servo0"
C"^probe"Those are not valid pin names.
zprobe.in
. is correct.
For the servo where are you actually connecting the yellow wire of the bltouch? -
@phaedrux they are correct for an SKR-RRF-E3.
Pin names are here https://teamgloomy.github.io/skr_rrf_e3_pins.html -
@jay_s_uk I completely missed that this was an SKR board.