M302 P1 needs active heater
-
Hi,
I've upgraded to firmware 3.3.0.
Has M302 P1 which is used to allow cold extruding always required the heater to be active even though the temp settings (R/S) can be zero?
Thanks.
Frederick
-
M302 P1 should not care whether heaters are active or not. However, it has always been the case that you must have a tool selected in order to extrude.
-
@dc42 said in M302 P1 needs active heater:
M302 P1 should not care whether heaters are active or not. However, it has always been the case that you must have a tool selected in order to extrude.
I will double check but it seems to me in v3.3.0 (which I just upgraded too) I found I had to activate the heater as well as have a tool selected.
The purpose of cold extruding in my case is when I am building a printer I can check the extruder stepper setup while cold.
Frederick