New layer detection?
-
Hmm, that made no differnce….
It thinks we are at layer z although Z is 40 (and 20mm layers)
-
sorry,it think we are at layer 0, I wrote layer z
-
-
How many 20mm high layers had you printed when you took that screenshot?
The estimate based on filament (concrete?) consumption should start to kick in when 1% of the total filament has been used. So I'm surprised that it isn't shown.
-
Just one, but I am now 3% into the gcode, and still nothing.
top of window
bottom
-
So we are now 6 layers in.
-
No more insight to share?
-
I printed 10 layers and still no timing reading.
-
I have identified the problem. The print monitor code assumes that printing hasn't started unless there is at least one active heater, and all active heaters have reached their set temperature. I presume you don't have any tool heaters, or else you have configured a heater for tool 0 but you haven't set a temperature. What is your M563 command for tool 0?
I need to work out how I can fix this without breaking the code for normal filament printing.
-
You could make a fake heater that will report back any temperature that it has been asked to reach.
Kulitorum