Unable to maintain target temperature with big nozzle
-
I have tuned the PID to 280°C of my volcano hotend with 1.2mm nozzle and 24v 40W heater cartridge.
Now I want to print at 40mm/s 260°C but the hot end is unable to maintain the target temperature because of high flow of plastic. (layer fans are Off)Is there any work around ?
-
I've never used a Volcano, but here are some suggestions:
-
Use a silicone sock on the heater block.
-
Turn the PSU voltage up a little (maximum recommended for a Duet is 25V).
-
Get a 50W or 60W heater cartridge.
-
Use the lowest M307 dead time setting that doesn't cause temperature oscillations. That will help the PID react faster to changes in flow rate.
-
-
- Using the sock
- I will try
- ordered a 50W cartridge, never seen a 60W can you point me to a shop please ?
- lowest value I can use is D3 for the dead time