First time trying bed mesh compensation - Question
-
Hi,
This is my first time trying bed mesh compensation on one of my mini-kossels.
Attached is my heightmap.csv file created using 80mm for the probing radius.
It "turns up" at the corners. So what does that tell me and what, if anything, can I do to correct it?
Thanks.
Frederick
-
Can you confirm that on your machine, +X is to the right, +Y is towards the rear, and the Z tower it at the back? Your height map has an element of 120 degree symmetry, but the ridges and valleys don't line up with where I expect the towers to be.
-
Hi,
Using the DWC jog controls X+ is to the right and Y+ is to the rear.
I checked the wiring and the Z tower motor is connected to the Z connector on the Duet WiFi.
Thanks much.
Frederick
-
In that case I can't tell exactly what the issue is. There is a list of common issues with delta printer geometry at https://duet3d.dozuki.com/Wiki/Calibrating_a_delta_printer#Section_Make_sure_your_build_is_accurate.
-
@dc42 said in First time trying bed mesh compensation - Question:
In that case I can't tell exactly what the issue is. There is a list of common issues with delta printer geometry at https://duet3d.dozuki.com/Wiki/Calibrating_a_delta_printer#Section_Make_sure_your_build_is_accurate.
Thanks. I will check that out.
Frederick