How to change default x/y speed between G30 probing points?
-
My leveling macro has this code to measure at the four leveling screw points
G30 P0 X26 Y29 Z-99999 ; front / left G30 P1 X266 Y29 Z-99999 ; front / right G30 P2 X266 Y269 Z-99999 ; rear / right G30 P3 X26 Y269 Z-99999 S4 ; rear / left + report
Is there a way to speed the x/y movement speed between the probing points? The mesh command M558 supports a speed parameters T but I don't see anything similar for G30.
Edit: fixed F parameter to T parameter.
-
M558 T parameter is the travel speed between points.
-
Thanks @phaedrux, is there a similar trick to control the x/y movement speed between G30 leveling points?
-
What happens if you set the feed rate before the G30 lines?
-
@zapta said in How to change default x/y speed between G30 probing points?:
Thanks @phaedrux, is there a similar trick to control the x/y movement speed between G30 leveling points?
The same parameter controls both.
-
@dc42 said in How to change default x/y speed between G30 probing points?:
The same parameter controls both.
Thanks dc42. I tried to add T10000 to the G30 commands but it doesn't see to affect the x/y movement between the probing points.
G30 P0 X26 Y29 Z-99999 T10000 ; front / left G30 P1 X266 Y29 Z-99999 T10000 ; front / right G30 P2 X266 Y269 Z-99999 T10000 ; rear / right G30 P3 X26 Y269 Z-99999 T10000 S4 ; rear / left + report
Is this the right parameter to use with G30? Any idea how to control the x/y travel speed between G30 probing points?
-
No that format is not quite right.
The T value goes in M558 in your config.g, not in the G30 command in bed.g.
What happens if you add G1 F10000 before the G30s?