Navigation

    Duet3D Logo

    Duet3D
    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    USB socket pulled off the board

    Duet Hardware and wiring
    3
    4
    176
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Colin Kent
      Colin Kent last edited by

      Unfortuneatly I left the USB plug connect to mt DUEt2 wifi. When I moved the gantrey the lead got caught and pulled USB socket almost off the to an angle of 90 degrees. Ive pushed it flat again but it no longer connects. Is there any way I can get this repaired ?

      Martin1454 1 Reply Last reply Reply Quote 0
      • Martin1454
        Martin1454 @Colin Kent last edited by

        @colin-kent depending on how good you with a soldering iron and how bad the traces/pads for the usb is damaged.

        Colin Kent 1 Reply Last reply Reply Quote 0
        • A Former User
          A Former User last edited by

          The biggest problem with repairing such a thing is without the pads to anchor the port it will be quite weak.

          Clean up the port and board, remove solder mask from traces, solder wires from port to traces, epoxy port in place. Fiddly work, but absolutely doable.

          1 Reply Last reply Reply Quote 0
          • Colin Kent
            Colin Kent @Martin1454 last edited by

            I Have found the socket on RS. I have the tools, not sure about my eyesight but will have a go I think

            1 Reply Last reply Reply Quote 0
            • First post
              Last post
            Unless otherwise noted, all forum content is licensed under CC-BY-SA