Solved I cant remember.... gcode for plain prints
-
Hi,
to make flat prints without using the compensation ....
I remember that in the gcode it was indicated the height from which the impression was completely flat, and from the bed until that height what it was was to compensate for it ...What was that gcode? Where do you have to enter it? (in the slicer? in config.g ?, in another site ...?
Thank you
-
@peirof see https://duet3d.dozuki.com/Wiki/Gcode#Section_G29_Detailed_Z_Probe
The S2 parameter turns off the mesh.
Of you want the mesh to fade out after a certain amount of printing then see:
https://duet3d.dozuki.com/Wiki/Gcode#Section_M376_Set_bed_compensation_taper -
this is.... thanks