I think my 2nd extruder driver is fried.
-
Hello, I was instructed by Tim from Filastruder and Tony from Duet3D to post here.
My Duet 2 WiFi has been working fine for a few months now. Today I wanted to add another extruder. I configured it. Turned off the printer. plugged it in. I'm not sure if when I restarted the duet or if I tried to extrude, but I heard this popping noise and a burning smell. After that, I saw "Error: short-to-ground reported by driver(s) 4" on my screen. There is a weird mark on the last stepper driver. I'm almost sure that was a popping noise. The 2nd extruder would not work.
I came across this post: https://forum.duet3d.com/post/29722
Is it possible my board can be repaired or replaced?
-
-
Hi viet,
Please check the wiring between that stepper driver output and the motor carefully for short-circuits. If you are satisfied that the wiring is sound, I approve a replacement or repair under warranty.
-
Hello I carefully checked the wiring between the problematic stepper driver output and the motor for short-circuts. I appreciate your approval for replacement of repair.