M562 - clear fault & can run PID autotune but not simple G10 ?
-
Just had a heater fault:
14:28:37Error: Heating fault on heater 1, temperature rising much more slowly than the expected 0.3°C/sec
Tried:
M562 and M562 P0
but was unable to set the hotend heating again with a
G10 P0 S275
Finally, in order to try something other than restarting, launched a PID autotune for P0 and it is running fine. So in some sense the fault has been cleared.
Why can't I execute a G10 after a M562 and see the temperature rise again? What should I do?
Firmware 2.03
-
Try re-selecting the tool after clearing the heater fault with M562.