external Stepperdriver direction phenomenom

  • Hello, I have the following problem:
    I have two motors on the x-axis , as soon as the printer moves in the positive direction both motors run synchronously.
    But in the negative direction the motors run to different directions. It's the complete opposite of how they should work.
    Why does this happen and why do they not run synchronously in both directions?

    ; Drives
    M584 X10:11 Y3 Z0 E1 ; remapping drives
    M569 P10 S0 ; Physical drive 0 goes forwards
    M569 P11 S1 ; Physical drive 1 goes forwards
    M569 P0 S0 ; Physical drive 2 goes backwards
    M569 P3 S1
    M569 P1 S1 ; Physical drive 3 goes forwards
    M350 X16 Y16 Z16 E16 I1|1 X16 ; Configure microstepping with interpolation
    M92 X2000.00:2000 Y400.00 Z400.00 E420.00 ; Set steps per mm
    M566 X900.00 Y900.00 Z12.00 E120.00 X900 ; Set maximum instantaneous speed changes (mm/min)
    M203 X6000.00 Y6000.00 Z180.00 E1200.00 X6000; Set maximum speeds (mm/min)
    M201 X500.00 Y500.00 Z20.00 E250.00 X500 ; Set accelerations (mm/s^2)
    M906 X1600.00 Y1600.00 Z1600.00 E1600.00 I30 ; Set motor currents (mA) and motor

  • administrators

    So one of the motors always runs in the same direction? It sounds like its driver is not getting the direction signal.

Log in to reply