Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    Guidance Needed Please

    General Discussion
    3
    4
    70
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Shaun
      Shaun last edited by

      Hi All

      SO after finally getting the wifi board set up and configured things dont seem to work as expected.

      I have a CR10, installed the Duet wifi board. connected all the connectors accordingly. So here is where i am stuck.

      I used the configuration wizard to get my initial configuration done. I can now get each individual part working, bed heats nicely and quickly. Hotend, stepper motors. That all said, i cant seem to get them all working together.

      Any suggestions of where i should start looking? Does anyone have a working config for the CR10?

      Upgrades: E3D Titan DD and motor with V6 hotend.

      Thanks
      Shaun

      T3P3Tony 1 Reply Last reply Reply Quote 0
      • droftarts
        droftarts administrators last edited by

        Though aimed at the Duet Maestro, this series of How-to guides for Ender 3 Pro (pretty similar to the CR10) here walk you through the process, and most information is compatible with the Duet Wifi:
        https://duet3d.dozuki.com/c/Duet_2_Maestro#Section_How-to
        If you could be a bit more specific about how you can't "get them all working together", that would help!

        Ian

        Cartesian bed-slinger with Duet 3 Mini 5+ WiFi : RRP Fisher Delta v1 with Duet 2 Maestro : TronXY X5S with Duet 2 Wifi (in progress)

        1 Reply Last reply Reply Quote 0
        • T3P3Tony
          T3P3Tony administrators @Shaun last edited by T3P3Tony

          @Shaun so if you have got every part working individually then you probably have done the majority of the steps in this guide:
          https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+3:+Commissioning/39
          but check.

          Then I would move onto the next guide:
          https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+4:+Calibration/40

          I know these are for a slightly different printer and controller but the theory remains valid - just tweak the numbers to fit with the CR10 size etc.

          (the second guide in that series has some steps about how to get the numbers form the old configuration)

          @droftarts was too quick!

          www.duet3d.com

          1 Reply Last reply Reply Quote 0
          • Shaun
            Shaun last edited by

            Thanks, ill try it tonight.

            1 Reply Last reply Reply Quote 0
            • First post
              Last post
            Unless otherwise noted, all forum content is licensed under CC-BY-SA