How setup Slic3r 2.x?
-
Hi,
i am giving a try to Slic3r v2... when i start to print, i see often a message in console...
Warning: M73 command is not supported
I have see its a command, M73, not supported by Duet....
There is some form of configuration Slic3r, to generate a gcode, more compatible with Duet??
Thanks
-
I'm pretty sure if you select RepRap/Sprinter as Firmware Type then no M73 GCodes are created.
Alternative you could create a empty file called /sys/M73.g. This should work with firmware > 2.03 as described in https://duet3d.dozuki.com/Wiki/G-Codes_not_implemented -
@mloidl said in How setup Slic3r 2.x?:
I'm pretty sure if you select RepRap/Sprinter as Firmware Type then no M73 GCodes are created.
Alternative you could create a empty file called /sys/M73.g. This should work with firmware > 2.03 as described in https://duet3d.dozuki.com/Wiki/G-Codes_not_implementedHi,
i will try create M73.g, because i have selected Reprap/Sprinter mode.... and the error messages flood the console
-
Later i'll check why i'm not getting these messages. Maybe it's a kind of configuration somewhere
-
@peirof said in How setup Slic3r 2.x?:
i will try create M73.g, beca
disable the support remaining times flag
-
Can now confirm that "Supports remaining times" is what you have to untick to not get these M73 GCodes.
-
Thanks....