Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    RRF Config Tool Bug

    General Discussion
    2
    2
    80
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • atmark
      atmark last edited by

      Hi

      I've been trying to setup three thermocouples over the last days using two temp daughterboards. Up until now, I was only able to get a reading from the first two sensors. Today, I tried the RRF v3 on my Duet 2 Wifi.

      I used the RRF Config Tool to create a fresh set of files. Then, I tried them and I got even less response from the sensors. Suddenly, all of them seemed to be dead. After looking up the new M308 syntax https://duet3d.dozuki.com/Wiki/RepRapFirmware_3_overview#Section_M308_Create_or_modify_sensor_or_report_sensor_parameters and referencing that to the generated config files I realized that there is a bug in the config tool.

      This is the command it should be: M308 S1 P"spi.cs1" Y"thermocouple-max31855"
      And instead the online tool gives you this: M308 S1 P"spi.cs1" Y"max31855"

      Please fix this.

      Other than that, my struggle is still far from over. Now there is still a real fault in the thermocouple... The sheath it shorted to the signals 😰

      1 Reply Last reply Reply Quote 0
      • T3P3Tony
        T3P3Tony administrators last edited by

        thanks for reporting this. hopefully @chrishamm will get chance to fix it shortly.

        www.duet3d.com

        1 Reply Last reply Reply Quote 0
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA