Using PL08-N probe getting bad command r0.2
-
homeall.g This is a new setup on corexy printer (voron)
Been weeding out problems as I go, been slow but productive till this.Message response is Bad command r0.2 when I activate z_probe_ macro.
[0_1581953284105_config](Uploading 100%)
Firmware Name: RepRapFirmware for Duet 2 WiFi/Ethernet
Firmware Electronics: Duet WiFi 1.02 or later + DueX5
Firmware Version: 2.05.1 (2020-02-09b1)
WiFi Server Version: 1.23
Web Interface Version: 1.22.6Going to use probe for homez is the plan, need to figure it out also.
Any help or guidance is appreciated.
CarlJ
-
Your file activate_z_probe.g comprises 4 good lines, then 57 blank lines, then a final line that reads "r0.2". That final line provokes the error message.
-
Very good, guess need to scroll down alot to see it.
Fixed that.
Now to proceed to next hurdle. Usually I find what I need looking thru the posts. So I don't make many requests.
It's been a learning experience.Thank You