Driver Z not Working



  • Hi Everyone

    I got my Duet 2 WiFi last Week, i have been upgrading my Ender 3. Everything went fine and today i finally today i tried to print

    Everything homed apart from my Z, The Z Driver wasn't moving. I get the following issues. I get the following error message
    1590078936363-a101206b-5976-4426-9faa-4b51d5338152-grafik.png

    Motor worked when remapped to another driver. X, Y and E are all working fine.

    I pulled everything apart to see I have noticed a small hole in my Z Chip. That's the only thing i can see that's different
    Capture1.PNG

    What the best workflow steps to solve the issue

    Thanks in advance

    P.S. The Macro system and general interface of the board and RepRapFirmware is great.


  • Moderator

    Please post your config.g

    Have you tested a working motor on that driver?
    Have you tested your Z motor on a working driver?


Log in to reply