Navigation

    Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    G30 S-2 Multi-touch support

    Beta Firmware
    1
    1
    25
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • techild
      techild last edited by

      I have two (2) z probes (K0 and K1) both configured in M558 with the A and S parameters.

      G30 without any parameters (defaulting to probe 0) works as expected touching off at least 2x, and more as needed such the deviation is less than the value specified in the S parameter of M558.

      When I try to use G30 S-2 K1, I do not get the multi-touch effect. It only touches off once.

      Is it possible to get this support?

      1 Reply Last reply Reply Quote 0
      • First post
        Last post
      Unless otherwise noted, all forum content is licensed under CC-BY-SA