Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

SSR connected directly to the expansion connector

Duet Hardware and wiring

2

2

380

Log in to reply

Mike last edited by

I'm setting up my heated chamber with the heater controlled by a solid state relay. Question: can I run it directly from one of the pins on the expansion connector or do I need a mosfet to drive the SSR? Wouldn't want to overcurrent and burn out the pins.
1 Reply Last reply
Reply Quote 0
dc42 administrators last edited by

You can connect the SSR control terminals between the expansion connector pin and +3.3V.
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com
1 Reply Last reply
Reply Quote 0

1 / 1