DWC Layer chart stuck at layer 1
-
Hi,
While printing a simple cube I noticed the layer chart doesn't do anything, it remains at layer 1. Also the text above the layer chart doesn't update layers, only percentage print time.
RRF 3.1.1 , DWC 3.1.1Is this a bug or is there a setting I'm unaware of ?
-
have you tried a different slicer?
-
No, I have Cura 4.7.1 but no other slicers.
Could it be something in the start or end codes ? -
@mbunjes said in DWC Layer chart stuck at layer 1:
Could it be something in the start or end codes ?
Most likely. Please share a sliced gcode file.
-
-
T0 M190 S60 M104 S205 M109 S205 M82 ;absolute extrusion mode G28 ;Home G92 E0 G1 F12000 X180 Y200 E5 G1 F3600 E25 ; Prime G1 Z5 ; Raise Nozzle G1 F3600 X0 Y0 Z0.3 ; Goto x0y0 – Release backpresssure G92 E0 ; Zero extruder G29 S1 G1 F6000 ; Print M83 ;relative extrusion mode G10 ;LAYER_COUNT:125 M572 S0.000000 D0 ;added by LinearAdvanceSettingPlugin ;LAYER:0 M107 M204 T2000 M566 X900 Y900 G1 F600 Z1.2 ;MESH:flow_cube_0.8.stl G0 F7500 X181.95 Y178.05 Z1.2 M204 P2000 ;TYPE:WALL-OUTER G1 F600 Z0.2
It could be this line
G1 Z5 ; Raise Nozzle
which I don't think you really need.Followed by this line
G1 F3600 X0 Y0 Z0.3 ; Goto x0y0 – Release backpresssure
you can try adding;E0
after theZ0.3
It also looks like cura is adding it's own Z moves before finally moving to the layer height. I don't think I've seen it do that before.
G1 F600 Z1.2 ;MESH:flow_cube_0.8.stl G0 F7500 X181.95 Y178.05 Z1.2
-
Ok, thanks. I'll give it try.