Warnings when using Load Filament but shouldn't get them
gnydick last edited by
Here's my load macro at the bottom. Why is the machine telling me the following error when there is no extrusion called for while the machine is cold?
1:42:35 PMWarning: Tool 1 was not driven because its heater temperatures were not high enough or it has a heater fault 1:42:31 PMM701 S"PETG" M703 Warning: Tool 1 was not driven because its heater temperatures were not high enough or it has a heater fault
M291 P"Please wait while the nozzle is being heated up" R"Loading PETG" T5 ; Display message G10 S240 ; Set current tool temperature to 240C M116 ; Wait for the temperatures to be reached M291 P"Feeding filament..." R"Loading PETG" T5 ; Display new message M83 ; Extruder to relative mode G1 E120 F6000 ; Feed 120mm of filament at 100mm/sec G1 E10 F300 ; Feed 10mm of filament at 5mm/sec G4 P1000 ; Wait one second M292 ; Hide the message
Firmware 1.17 on a Duet Maestro I assume?
Is it waiting for the temp to be reached?
Does the error happen immediately or does it happen after it waits for the temp to be reached?