Warnings when using Load Filament but shouldn't get them
-
Here's my load macro at the bottom. Why is the machine telling me the following error when there is no extrusion called for while the machine is cold?
1:42:35 PMWarning: Tool 1 was not driven because its heater temperatures were not high enough or it has a heater fault 1:42:31 PMM701 S"PETG" M703 Warning: Tool 1 was not driven because its heater temperatures were not high enough or it has a heater fault
M291 P"Please wait while the nozzle is being heated up" R"Loading PETG" T5 ; Display message G10 S240 ; Set current tool temperature to 240C M116 ; Wait for the temperatures to be reached M291 P"Feeding filament..." R"Loading PETG" T5 ; Display new message M83 ; Extruder to relative mode G1 E120 F6000 ; Feed 120mm of filament at 100mm/sec G1 E10 F300 ; Feed 10mm of filament at 5mm/sec G4 P1000 ; Wait one second M292 ; Hide the message
-
Firmware 1.17 on a Duet Maestro I assume?
Is it waiting for the temp to be reached?
Does the error happen immediately or does it happen after it waits for the temp to be reached?