IDEX, THE U AXIS DOES NOT MOVE WHEN I HAVE T2 ACTIVE
-
I have configured the 0 of my machine in the center of the bed, I activate t2 which is my tool for x + u but it prints x, u uses the extruder motor but the axis does not move.
This is my config.g; Tools
M563 P0 D0 H1 ; define tool 0
G10 P0 X0 Y0 Z0 ; set tool 0 axis offsets
G10 P0 R0 S0 ; set initial tool 0 active and standby temperatures to 0C
M563 P1 D1 H2 X5 F2 ;la herramienta 1 usa el extrusor 1 y el calentador 2 y asigna X a U, usa el ventilador 2 como ventilador de enfriamiento de impresión
G10 P1 Y0 U0 Z0 S0 R0 ; establecer compensaciones y temperaturas de la herramienta 1
G10 P1 R0 S0 ; set initial tool 0 active and standby temperatures to 0C
M563 P2 D0: 1 H1: 2 X0: 5 F0: 2 ;la herramienta 1 usa el extrusor 1 y el calentador 2 y asigna X a U, usa el ventilador 2 como ventilador de enfriamiento de impresión
G10 P2 X-30 Y0 U10 Z0 S0 R0 ; establecer compensaciones y temperaturas de la herramienta 1
G10 P2 R0 S0 ; set initial tool 0 active and standby temperatures to 0C
M567 P2 E1: 1 -
@vhervas Please post your entire config.g
G10 P2 X-30 Y0 U10 Z0 S0 R0 ;
Are you sure this is correct? One of these examples is typically more common:
G10 P2 X100 Y0 U-100 S0 R0
G10 P2 X0 Y0 U-200 S0 R0
It is important to note the positive/negative values for the G10 commands.
M563 P2 D0: 1 H1: 2 X0: 5 F0: 2
Does your actual M563 command have spaces after : ? "D0: 1" instead of "D0:1" etc