Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    V 3.2 Firmware Heatbed PID tuning doesn't seem to finish

    Tuning and tweaking
    3
    4
    136
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • jaymcd0626
      jaymcd0626 last edited by

      I ran the M303 command to re- pid tune after upgrading to V3.2. The tool 1 extruder tuning seemed to work fine but the bed tuning seems to get stuck on phase 4 - or is taking an extraordinary time to finish.

      This is the command I sent - M303 H0 S60.

      Thanks

      Jay

      PCR 1 Reply Last reply Reply Quote 0
      • PCR
        PCR @jaymcd0626 last edited by

        @jaymcd0626 can take up to 1 hour!

        deckingman 1 Reply Last reply Reply Quote 0
        • jaymcd0626
          jaymcd0626 last edited by

          hmm - ok thanks

          1 Reply Last reply Reply Quote 0
          • deckingman
            deckingman @PCR last edited by

            @PCR said in V 3.2 Firmware Heatbed PID tuning doesn't seem to finish:

            @jaymcd0626 can take up to 1 hour!

            .........Or with a 10mm thick, insulated bed more like 2 hours (I know from experience). 🙂

            Ian
            https://somei3deas.wordpress.com/
            https://www.youtube.com/@deckingman

            1 Reply Last reply Reply Quote 0
            • First post
              Last post
            Unless otherwise noted, all forum content is licensed under CC-BY-SA