Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Sync 3 independent z axis stepper motors.

    Scheduled Pinned Locked Moved
    General Discussion
    2
    3
    140
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • stuart.simpsonundefined
      stuart.simpson
      last edited by stuart.simpson

      I am trying to find out how to configure a coreXY 3D printer with three stepper motors each using a different driver. so:
      X-Axis on driver_0
      Y-Axis on driver_1
      Z-Axis Stepper 1 on drive_2
      Z-Axis Stepper 2 on drive_3
      Z-Axis Stepper 3 on drive_4

      Duet 3 Mainboard 6HC Revision v1.01
      Raspberry Pi 4 4GB

      I assume that there is an article out here that talks about doing it but I have been unsuccessful at finding it. I am happy to do the reading but could someone point me in the right direction.

      I am hoping this can be done in the RepRapFirmware Configuration Tool (may be a bad hope 🙂 )
      Thanks for the help.

      Stu

      1 Reply Last reply Reply Quote 0
      • Vetiundefined
        Veti
        last edited by

        see

        https://duet3d.dozuki.com/Wiki/Bed_levelling_using_multiple_independent_Z_motors

        it can not be done in the configuration tool

        1 Reply Last reply Reply Quote 1
        • stuart.simpsonundefined
          stuart.simpson
          last edited by

          Thank you for pointing me in the right direction.

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA