Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    A newbie has some questions about the speed parameters

    Tuning and tweaking
    2
    2
    99
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • GuruSMI
      GuruSMI last edited by

      Hey there,

      i'm quite new to Duet, RRF aswell 3D Printing. As a first printer i bought an Anycubic Predator- Within the last half year I did disassemble and rebuild the whole maschine. A bit more detailed:

      • Changing the Mainboard to Duet2Ethernet (RRF 3.2)
      • Changing to PanelDue 7i
      • Adding a Duet Smart Effector
      • repositioning the original Filamentsensor to the inner of the electronics Box
      • Changing the Extruder tio a Bndtech BMG
      • Changing the steppers to Nema17 with 65Ncm
      • Migration towards Volcano with 60W Heater and PT100 incl. Daughterboard
      • Integrating Linear Rails
      • integrating MagBallArms by Haydn Huntley
      • Changing the Z-Probe Sensor (Inside SmartEffektor
      • Changing nearby every cable towars AWG20
      • Adding the headbet with a magnetic springsteelplate with an applied original BuildTak sheet and also a BuildTak PEI Sheet
      • Added an enclosure with an additional temp control
      • a lot more small things like anti damping feet, heatbed insulation,...

      I did also write almost all of the configuration and Macros instead of using those from others. Everything runs fine so far. My main goal was to get a reliable and acurate machine not more slowly than the original. At all most of them is reached. Only the speed is quite slow.

      So my question for Understanding. Is there a standard procedure to evaluate versatile and reliable speedparameters? Or is it more a kind of "try and fail"?

      Thanks in advance for your patience and input. If needed don't hesitate to request for additional information. At least i'm sorry about my english as i'm not a native but a german.

      droftarts 1 Reply Last reply Reply Quote 0
      • droftarts
        droftarts administrators @GuruSMI last edited by

        @gurusmi because it depends so much on the machine, and they are all different, it is mostly “try faster until it fails”! However, you will usually get poor results before failure. @Phaedrux created a set of macros and a guide to tuning speed, see https://forum.duet3d.com/topic/6181/tuning-macros-menus-accel-jerk-retraction-pressure-advance

        Ian

        Cartesian bed-slinger with Duet 3 Mini 5+ WiFi : RRP Fisher Delta v1 with Duet 2 Maestro : TronXY X5S with Duet 2 Wifi (in progress)

        1 Reply Last reply Reply Quote 1
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA