Use Heater 5 pin as Temperature driven fan
the_dragonlord last edited by
Good morning, I am about to end my new mods for using an original water cooled Chimera +. I want to make the E3D water cooling kit to work only when the T0 temp is above 50°C (now I use this feature with a "real" fan) due to the current limitation of the Fan 0 pin I've decided to use the free heater 5 pin to drive a Mosfet wich will drive the cooling system (I want to be sure not to make "flow" too much current in the board). My question is how to reconfigure the heater 5 pin "to be" a fan and use it for my purpose?
o_lampe last edited by
same procedure as every year, James (quoted from the TV sketch 'Dinner for One')
M950 Fx C"heater5-pinname " Q500 M106 Px LminPWM SmaxPWM Hn T50