ToolBoard and Magnetic Sensor
metty last edited by metty
I made the error, and just connected them with a cable like on this Picture:
Only when it didn't work did I see that the connector on my Magetic sensor board is soldered on in reverse. Would be helpful to have an actual picture or a polarity warning on the website. I was certainly not very smart to make and connect the cables blindly as in the picture. But I thought, if there is already such a nice picture, it will surely be right.
One of my four toolboards is offline now.. I am currently analyzing why exactly. I hope no hardware was broken cause of the wrong connection.
Edit: Somehow it reset the CAN address. The toolboard is now online again..
@metty thanks for pointing that out. I have updated the picture and also added a note that different versions of the Magnetic Filament monitor had different pinouts.
metty last edited by
@t3p3tony I have to thank you! Luckily nothing was broken.