Unsolved DWC Fan Slider reacts faster than a macro?
fotomas last edited by
I have configured some LED lights to be powered via one of the heaters on my Duet 3 Mini 5+ (FW 3.3). The lights are controllable via a fanslider in the DWC.
;LED Lights M950 F3 C"out1" Q500 M106 P3 C"LEDs" S1
I have two macros to turn them on/off:
M106 P3 S1.0
M106 P3 S0.0
During a print fan slider changes are instantaneous but the macros takes a while.
What is the cause of this and can the macros be altered to have effect as fast as the fan slider?
Does the fan slider send another command than
M106or does macros have lower priority than single commands?
Does the fan slider send another command than M106 or does macros have lower priority than single commands?
That may be due to the way that DWC is sending commands to the Duet versus the macro getting called.
How much delay are you seeing? How are you executing the macro?
fotomas last edited by fotomas
It takes somewhere around 3 seconds.
I execute the macros by clicking buttons in the DWC.