Smart effector sensitivity
mfoltz last edited by
I recently got the smart effector, and i am loving it. One question though, I am trying to put a script in my slicer to turn the sensitivity down (20-30) for my pre print calibration run and then turn it up (60-70) for the pring. I used the g code for adjusting the sensitivity from the wiki but it does not seem to adjust it. Where in the interface could I look to see what the sensitivity is set to? I have noticed in settings>machine properties there is a window for z probe that has a trigger value that always says 100. is this the sensitivity and if so why does it never change even when I input the g code M672 S105:50:205 as the wiki says?
sungod3k last edited by
Why do you want to change the sensitivity? Do you get errors during the print that stem from it?
and the wiki describes a blinking pattern of the LED that confirm if your are on the default or if it accepted your custom value.
Personally, i also though i needed to change the sensitivity but after 2-3 test I went back to default and havent had an issues since.