How to correctly setup power failure detection/resurrection in 1.20?
-
UNEXPECTED BEHAVIOR CONFIRMATION
I just successfully resurrected this print despite not having M911 defined in config.g
-
It must have automatically commanded the pause script, because it parked itself. I speculation that there was a short brownout this morning to account for it having enough power to park itself. I know you're saying that's not possible, but it did… I was sleeping when the print stopped itself, and on resurrect it picked right up where it left off.
-
Lucky you!
-
Yeah but, it seems like it issued the pause script on its own somehow. The gantry was parked, mid print. Any idea why it would do that?
-
Did I forget to mention the new firmware precognition feature?
An alert from a filament monitor will also cause a pause.
