Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    Bug ?: layer count during dual print

    Duet Web Control wishlist
    4
    6
    662
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Falc.be
      Falc.be last edited by

      So i just noticed this

      During a dual print, every toolchange counts as 1 layer done. However while the total layers shown is correct. The total printed layers reaches 100% when in actuality the print is only 50% done

      1 Reply Last reply Reply Quote 0
      • dc42
        dc42 administrators last edited by

        Do you have Z lift configured in your tool change files? That might be confusing it.

        Duet WiFi hardware designer and firmware engineer
        Please do not ask me for Duet support via PM or email, use the forum
        http://www.escher3d.com, https://miscsolutions.wordpress.com

        1 Reply Last reply Reply Quote 0
        • stephenc
          stephenc last edited by

          I was also confused with that too. In S3D when slicing dual print I noticed every toolchange means layer number change. It doesn't make sense to tie layer number with toolchange…

          Stephen
          https://github.com/stephenci/ZideX

          1 Reply Last reply Reply Quote 0
          • dc42
            dc42 administrators last edited by

            Please share a gcode file that demonstrates the problem, also your config.g file.

            Duet WiFi hardware designer and firmware engineer
            Please do not ask me for Duet support via PM or email, use the forum
            http://www.escher3d.com, https://miscsolutions.wordpress.com

            1 Reply Last reply Reply Quote 0
            • kazolar
              kazolar last edited by

              I see the same thing. The layer total time estimate is 0. Quad color in my case. I have z-lift, but it doesn't have any trouble with z-lift for single color prints. Multi color – a few issues -- the S3D analysis of the GCode says the part is 10mm tall (it isn't) -- it's a 2X size benchy boat, so it is whatever that size is. Also layer count is wrong.

              1 Reply Last reply Reply Quote 0
              • dc42
                dc42 administrators last edited by

                If someone can provide sample GCode files and config.g to demonstrate the problem within the next few hours, I can try to get a fix done in release 1.20.1. Otherwise a fix will have to wait until the next major release, which is many weeks away.

                Duet WiFi hardware designer and firmware engineer
                Please do not ask me for Duet support via PM or email, use the forum
                http://www.escher3d.com, https://miscsolutions.wordpress.com

                1 Reply Last reply Reply Quote 0
                • First post
                  Last post
                Unless otherwise noted, all forum content is licensed under CC-BY-SA