Two heaters and thermistors for heatbed

  • Hello
    My heat bed has two zones to be able to change between 24V supply and 12V supply.
    This leads to an uneven bed temperature if I connect them in parallel and even if i connect
    them in serial.
    For this reason I have connected the first part to the Bed output and the second part to the second
    extruder heater output.
    Is there a possibility in the firmware settings to use the bed temperature setting for both the Bed Heater
    and the second extruder heater?

  • administrators

    Meanwhile RRF supports multiple bed heaters. You may wish to look into this - if you need more customizations on DWC, I suggest you open a new topic.

Log in to reply