Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    Heater fault trouble

    Duet Hardware and wiring
    2
    2
    351
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Ricky_Grade10
      Ricky_Grade10 last edited by

      Alright boys, I'm getting a heater fault shortly after starting a print. I can autotune it fine and bring it up to temp, no big deal. But when I run a print, I get a fault after it starts. Is there one of those light things on the board to tell me when the hotend is working like the heat bed?

      1 Reply Last reply Reply Quote 0
      • dc42
        dc42 administrators last edited by

        Yes, there are LEDs on the board for each heater output.

        After running auto tuning, you need to save the parameters in one of two ways:

        • If you are not using config-override.g, then run M307 H1 to find the resulting parameters, and edit them into a M307 h1 command in config.g;
        • If you are using config-override.g, send M500 to save the heater parameters in config-override.g.

        See also https://duet3d.dozuki.com/Wiki/Spurious_heater_faults_and_how_to_avoid_them.

        Duet WiFi hardware designer and firmware engineer
        Please do not ask me for Duet support via PM or email, use the forum
        http://www.escher3d.com, https://miscsolutions.wordpress.com

        1 Reply Last reply Reply Quote 0
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA