Check Bed compensation...
-
Hi,
i d'like check if Heighmap in bedcompensation its ok...
What will be the procedure for check Heightmap??
Thanks
-
I usually move the nozzle tip close to the bed say 0.5mm above the bed and then move the nozzle around slowly and see if the height of the nozzle stays consistent.
-
@phaedrux said in Check Bed compensation...:
I usually move the nozzle tip close to the bed say 0.5mm above the bed and then move the nozzle around slowly and see if the height of the nozzle stays consistent.
I don't suppose there is any kind of utility that can generate a gcode file for doing this - one with just the XY movements.
I know I could create one "by hand" but it would be nice if there was a utility I could use.
Thanks.
Frederick
-
@fcwilt If you wanted to verify by printing I use this STL. Just scale it to your bed size
-
@phaedrux said in Check Bed compensation...:
@fcwilt If you wanted to verify by printing I use this STL. Just scale it to your bed size
Thanks.
I will give it a try.
Frederick
-
@phaedrux thanks