Motor Phase Problem
Richygoat last edited by
i'm new to the Duet Board and i'm actually building a V-King Printer and want to use the Duet Maestro board. As far as good. Most things are running. But i always get error messages when i move the axis.
Please see the picture attached. What could cause the failure?
Thanks for the help.
My guess is that you are running 2.02 beta firmware. We introduced the motor disconnected warning in the 2.02 beta series, but we didn't get it quite right until late in the beta cycle. So if the M115 command confirms that you are running beta or RC firmware, upgrade to the 2.02 release.