Duet3D Logo

    Duet3D

    • Register
    • Login
    • Search
    • Categories
    • Tags
    • Documentation
    • Order

    Solved Expansion Breakout board - Configure Drive 5 and 6 with endstops

    Tuning and tweaking
    2
    4
    310
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • skyline
      skyline last edited by

      Hi, I am using the duet expansion breakout control to drive 2 separate motors (Drive 5 and Drive 6 - referring to https://duet3d.dozuki.com/Wiki/Expansion_breakout_board) . However, I wish to configure them to work with the extruder end stops (E0 and E1). How would i go about doing this?

      Thank you in advance.

      1 Reply Last reply Reply Quote 0
      • dc42
        dc42 administrators last edited by

        You can do that in firmware 2.03beta2 using the new C parameter of the M574 command.

        Duet WiFi hardware designer and firmware engineer
        Please do not ask me for Duet support via PM or email, use the forum
        http://www.escher3d.com, https://miscsolutions.wordpress.com

        skyline 1 Reply Last reply Reply Quote 0
        • skyline
          skyline @dc42 last edited by

          @dc42 Thank you for the quick reply. I shall give it a go and report back.

          1 Reply Last reply Reply Quote 0
          • skyline
            skyline last edited by

            @skyline said in Expansion Breakout board - Configure Drive 5 and 6 with endstops:

            @dc42

            Works brilliantly!

            Thank you once again

            1 Reply Last reply Reply Quote 0
            • First post
              Last post
            Unless otherwise noted, all forum content is licensed under CC-BY-SA