Simulate issues...
-
Hi,
i am testing new slicer "Pathio v0.5".... and few times i simulate a file, but in this case, i have do it. And think, something its wrong, see you:
Screen capture of Pathio model sliced...
and a screen capture of results of simulate this file
Times by layer are very low.... in graph, layer time for first its about 5 sec....i doubt too much, the printer can do it.....
Nevertheless ... the total time, marks it as 1h 2m (in console, when the simulation ends) ... that if it is easy that it can be reached. If you notice, the total time in the simulation, in the print tab, is only 55 sec ....
-
The print page of DWC shows you how the simulation is progressing and when the simulation is estimated to end. The figure on the console at the end of the simulation says how long the file will actually take to print, and it is also written to the GCode file for later retrieval.